Water Flow Switch WFS 6000 Honeywell

Water Flow Switch WFS 6000 Honeywell

 

 

 

APPLICATION

The paddle type SPDT WFS series are designed to provide excellen t performance where accuracy,
reliability, and rugged construction are required used in liquid flow lines carrying water or any
fluid n either harmful to brass and prosphor bronze nor classified as a hazardo us fluids.

They can be wired to close one circuit and open a second circuit when liquid flow either exceeds or
drops below the adjusted flow rate .
The WFS series are recommended for liquid pressure and temperatu r as mentioned below and must not
be used on lines carrying liquid s bel 0 oC.

These series may be used on liquids with high salt or chlorine c ontent but is not for use in
hazardous atmospheres.
They may be also used outdoors but must be protected from weathe r splashing water.
All series WFS flow switches are designed for use only as operat ing controls.
Where an operating control failure would result in personal inju ry and/o loss of property, it is
the responsibility of user to add safety devices tha protect against, or supervisory systems that
warn of control fai lure.

•SPECIFICATIONS

Operating Pressure	10kgf/cm² (1000KPa)
Withstand Pressure	17.5Kgf/cm² (91750KPa)
Insulation Resistence	Over 100 ohm , DC500VM
Withstand Voltage	AC1500V/1minute
Contact Point Life	1000K Cycle
Bellows Life	500K Cycle
Temperature of Fluid	Max 100°C (212°F)

 

 

ELECTRICAL RATINGS
Type	Voltage	Resistence Load	Lamp Load	Motor Load
AC (Standard)	AC 125 V AC 250 V	5A 2.5A	44A 22A	5A 2.5A
DC	DC 115 V DC 230 V	0.3A 0.15A